Machine Design - Practice Test

(A) Surface of the top of the tooth

(B) Surface of the tooth above the pitch surface

(C) Width of the tooth measured along the pitch circle

(D) Surface of the tooth below the pitch surface

(D) Surface of the tooth below the pitch surface

(A) Surface of the top of the tooth

(B) Surface of the tooth above the pitch surface

(C) Surface of the tooth below the pitch surface

(D) Width of the tooth measured along the pitch circle

(B) Surface of the tooth above the pitch surface

(A) Fill up the axial gap

(B) Provide bearing area

(C) Provide cushioning effect

(D) Absorb shocks and vibrations

(B) Provide bearing area

(A) Increase shank diameter

(B) Increase its length

(C) Drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread

(D) Tighten die bolt properly

(C) Drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread

(A) 18

(B) 16

(C) 20

(D) 22

(A) 18

Machine Design - Study Mode