Engineering Drawing - Study Mode
[#161] In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct iso-plane has been selected by scrolling through the iso-planes using the ________ key.
Correct Answer
(C) F5
[#162] Approximately this much of the cost of product development and manufacture is determined at the design stage:
Correct Answer
(C) 70 - 80%
[#163] If a plane is parallel to the plane of projection, it appears:
Correct Answer
(A) True size
[#164] An accurate record of changes made to release drawings is tracked via this:
Correct Answer
(A) A revision block
[#165] The site plan illustrates _________.
Correct Answer
(B) Where the house sits on the property